Pfister F-529-9MDC Guía de instalación descargar pdf (Pagina 4)

ENGLISH

Water Supply Lines are not included. Please

consult manufacturer and/or its instructions for

the correct method of installation of supply lines

and ttings.

CAUTION: Incorrect application of supply lines and

ttings may result in the failure or leak of the supply lines

and ttings.

11 WATER SUPPLY CONNECTIONS

A.Thread inlet connectors (11A) into Water Supply Lines (11B).

B.Remove Protective Cap (11F). Gently separate HOT and COLD Faucet Inlets (11C),

approximately 1 in. (26 mm) apart. Connect Water Supply Lines (11B) onto Faucet Inlets

(11C). Hot Water supply goes to hot inlet tting indicated by red tag (11D).

C.Insert Clip (11E) into Inlet Connector Holes (11F) to secure water supply lines, as shown.

WARNING: Do not twist Faucet Inlets.

12 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink

13 FLUSHING

Remove Spray Head (13B) by turning it counterclockwise. By rotating the Lever Handle

(13A) away from the Faucet Body (13D), the valve will be activated allowing water to ow.

The water ow will increase by continuing to rotate the Lever Handle (13A). Run water for

one minute. Repeat in hot and cold positions. Reassemble the Spray Head (13B) to the

Hose (13C) by turning Spray Head (13B) clockwise.

Caution: do not over tighten spray head and hose.

HOT

1” Max.

(26 mm)

COLD

11C

11A

11C

11B

11E

11F

11A

11B

11E

11A

11F

11D

11A

11C

13A

13D

13A

13C

13B

OPEN

1 2 3 4 5 6 7 8 9 ... 16 17

Comentarios a estos manuales

Sin comentarios

Pfister F-529-9MDC Guía de instalación Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Grifos Pfister F-529-9MDC